User's Manual
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Compliance
- RF Statements
- Introduction
- Installation for the Street Lighting Solution
- Setting Up the Segment Controller
- Planning for the Street Lighting Solution
- Managing a Street Lighting Network
- Controlling a Street Lighting Network
- Interoperable Interface for the Street Light Bridge
- Cryptography License
- Glossary
Street Light Bridge Integrator’s Guide 127
Variable Description Modifiable?
nciLedTimeout Defines the timeout for the LEDs
on the Street Light Bridge module.
The timeout starts at each reset or
power up of the device.
Yes
Default value is 60 minutes. Set
to 0 (zero) to leave LEDs on
indefinitely, for example during
installation debugging. See
Verifying Successful Installation
on page
22 for more information
about the device LEDs.
nviErrMode Controls error simulation mode. Yes
See
Simulating Communications
Errors
on page 44 for information
about error simulation.
nviErrRate Defines the error rate for error
simulation mode.
Yes
nciErrTimeout Defines the error timeout for error
simulation mode.
Yes