Installation Guide
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Notice
- RF Statements
- EMC and Safety Statements
- 1. Introduction
- 2. Installing Components and Troubleshooting
- 3. Pole Mount Installation
- 4. Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- 5. Field Replacement for an ECN 7000 Series Device
- A. ECN 7000 Series Specifications
- B. Safety and High-Voltage Warnings
- C. ESD and Battery Warnings
ECN 7000 Series Hardware Guide 41
Figure 18. Attach the Conduit Housing to the Pad Mounting Bracket
Insert Conduit Thread into Conduit Housing
To protect the electrical and network cabling as it enters the Pad Mounting
Bracket Conduit Housing, insert a Conduit Thread unit into one of the available
holes in the bottom of the Conduit Housing. The Conduit Thread should
accommodate the locking nut for the conduit and the radius of one or more cable
bundles. The Conduit Housing provides three cutouts for conduits; at least one of
these should be precut to allow for insertion of the electrical and network cabling.
Insert the Conduit Thread into the Conduit Housing, as shown in Figure 19 on
page 42. You can perform this step prior to field installation.