Installation Guide
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Notice
- RF Statements
- EMC and Safety Statements
- 1. Introduction
- 2. Installing Components and Troubleshooting
- 3. Pole Mount Installation
- 4. Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- 5. Field Replacement for an ECN 7000 Series Device
- A. ECN 7000 Series Specifications
- B. Safety and High-Voltage Warnings
- C. ESD and Battery Warnings
ECN 7000 Series Hardware Guide 59
Category Rating
High Voltage Surge
ANSI C12.1 2008 4.7.3.3.1 100kHz Ring Wave in
accordance with ANSI C62.41 (Category B)
ANSI C12.1 2008 4.7.3.3.2 Combination Wave in
accordance with ANSI C62.41 (Category B)
Effect of Current Surge in
Ground Conductor
ANSI C12.1 2008 4.7.3.7
Safety Specifications
Table 9 summarizes the safety specifications for ECN 7650 devices.
Table 9. Safety Specifications
Category Rating
Safety
UL 60950, EN 60950, CSA 60960
CE Marking
RoHS-compliant
EMC Specifications
Table 10 summarizes the electromagnetic compatibility (EMC) specifications for
ECN 7650 devices.
Table 10. EMC Specifications
Category Rating
Immunity to Electrostatic Discharge:
Contact Discharge IEC 62052-11 (7.5.2), IEC 61000-4-2: 8 kV
Air Discharge IEC 62052-11 (7.5.2), IEC 61000-4-2: 15 kV
Immunity to Electromagnetic
RF Fields (80MHz to 2000
MHz)
IEC 62052-11 (7.5.3), IEC 61000-4-3: 30 V/m
Fast Transient Burst IEC 62052-11 (7.5.4), IEC 61000-4-4: 4 kV common mode