Installation Guide
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Notice
- RF Statements
- EMC and Safety Statements
- 1. Introduction
- 2. Installing Components and Troubleshooting
- 3. Pole Mount Installation
- 4. Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- 5. Field Replacement for an ECN 7000 Series Device
- A. ECN 7000 Series Specifications
- B. Safety and High-Voltage Warnings
- C. ESD and Battery Warnings
ECN 7000 Series Hardware Guide 53
Figure 27. Battery Pack Restraining Tab
To replace the battery pack:
1. Insert the battery pack into the battery compartment. The restraining
tab must be oriented toward the ECN cover. The restraining tab will
click into place.
2. Ensure that the battery pack’s gasket makes a good seal with the battery
compartment.
3. Insert and tighten the four sealing screws. Tighten the screws in a
diagonal “X” pattern (alternating top-left, bottom-right, top-right, bottom-
left). Tighten the screws to no more than 9.1 (±0.4) lbf-in (10.4 [±0.5] kgf-
cm) torque.