Installation Guide
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Notice
- RF Statements
- EMC and Safety Statements
- 1. Introduction
- 2. Installing Components and Troubleshooting
- 3. Pole Mount Installation
- 4. Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- 5. Field Replacement for an ECN 7000 Series Device
- A. ECN 7000 Series Specifications
- B. Safety and High-Voltage Warnings
- C. ESD and Battery Warnings
42 Pad Mount Installation
Figure 19. Insert a Conduit Thread into the Conduit Housing
Attach ECN to Pad Mounting Bracket
After the Pad Mounting Bracket is securely attached to the transformer, and the
Conduit Housing is securely in place, you can attach the ECN to the Pad
Mounting Bracket. The top of the back side of the ECN includes two tabs that
slide into the top of the Pad Mounting Bracket. Figure 20 on page 43 shows the
ECN attached to the Pad Mounting Bracket.
Note that if you should need to replace an ECN, you need replace only the ECN
and not the Pad Mounting Bracket.