Installation Guide
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Notice
- RF Statements
- EMC and Safety Statements
- 1. Introduction
- 2. Installing Components and Troubleshooting
- 3. Pole Mount Installation
- 4. Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- 5. Field Replacement for an ECN 7000 Series Device
- A. ECN 7000 Series Specifications
- B. Safety and High-Voltage Warnings
- C. ESD and Battery Warnings
56 ECN 7000 Series Specifications
General Specifications
Table 5 summarizes the general specifications for ECN 7650 devices.
Table 5. General Specifications
Category Rating
Input Voltage:
Single Phase
(Non-network)
Single Phase
(Network)
3-wire 120/240 V ±20% 60 Hz ±2%, 1 A
L1/L3 to N: 120 V; L1 to L3: 240 V
3-wire 120/208 V ±20% 60 Hz ±2%, 1 A
L1/L3 to N: 120 V; L1 to L3: 208 V
Maximum Voltage L1/L3 to N: 176 V
L1 to L3: 305 V
Battery Power Input (Optional)
Battery backup module (15 minutes)
Uninterruptible Power Supply (UPS) interface module
(input 12 V or 24 V)
Power Consumption
5 W typical
30 W maximum
Phase Coupling Connections for 3 phases (L1Φ, L2Φ, L3Φ) and Neutral.
Dimensions
H: 34.7 cm – W: 37.5 cm – D: 19.1 cm
(H: 13.67 in – W: 14.75 in – D: 7.52 in)
Weight
<6.4 kg
(<14 lb)
Enclosure UV stable plastic (grey or green); rated NEMA4
Connectors IP67 rated
Mounting Separate mounting kit
Security
Impact- and vandal-resistant metal
High-security screws
Tamper detection (operates whether powered or
unpowered)
Optional tilt detector
Serial Number Indication Text and barcode