Installation Guide
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Notice
- RF Statements
- EMC and Safety Statements
- 1. Introduction
- 2. Installing Components and Troubleshooting
- 3. Pole Mount Installation
- 4. Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- 5. Field Replacement for an ECN 7000 Series Device
- A. ECN 7000 Series Specifications
- B. Safety and High-Voltage Warnings
- C. ESD and Battery Warnings
46 Pad Mount Installation
Figure 23. Close and Lock the Conduit Housing
Complete the Installation
After the installation is complete, perform the following tasks:
1. Inspect the connection of the ECN to the Pad Mounting Bracket.
2. Inspect the connection of the Pad Mounting Bracket to the transformer.
3. Inspect the cabling connections to the ECN.
4. Inspect the transformer pad.
The completed installation should look similar to the views depicted in Figure
24 and Figure 25 on page 47. Note that the figures do not show the cabling
connections to the ECN.