Installation Guide
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Notice
- RF Statements
- EMC and Safety Statements
- 1. Introduction
- 2. Installing Components and Troubleshooting
- 3. Pole Mount Installation
- 4. Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- 5. Field Replacement for an ECN 7000 Series Device
- A. ECN 7000 Series Specifications
- B. Safety and High-Voltage Warnings
- C. ESD and Battery Warnings
ECN 7000 Series Hardware Guide 31
Figure 13. Attach the ECN to the Pole Mounting Bracket
Secure ECN to Pole Mounting Bracket
To secure the ECN to the Pole Mounting Bracket, secure the two captive ΒΌ-20
screws to the bottom of the ECN to attach it to the Pole Mounting Bracket.
These screws are already connected to the ECN, and are designed not to make
contact with the pole. Figure 14 on page 32 shows a front view of the ECN
attached to the Pole Mounting Bracket, with the bottom screws visible.