User's Manual
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Compliance Notice
- RF Statements
- EMC and Safety Statements
- Declaration of Conformity
- Introduction
- Pole Mount Installation
- Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- Field Replacement for an ECN 7000 Series Device
- ECN 7000 Series Specifications
- Safety and High-Voltage Warnings
- ESD and Battery Warnings
Edge Control Node 7000 Series Installation Guide v
This equipment complies with the FCC RF radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
EMC and Safety Statements
TBD
TÜV Certified per EN 60950, 2000, IEC60950, 2000,
UL60950, and CSA60950 by TÜV under NRTL
Declaration of Conformity
To Be Added
89/336/EEC, Electromagnetic Compatibility Directive (EMC), 73/23/EEC, Low
Voltage Directive (LVD)