User's Manual
Table Of Contents
- Welcome
- Audience
- Related Documentation
- FCC Compliance Notice
- RF Statements
- EMC and Safety Statements
- Declaration of Conformity
- Introduction
- Pole Mount Installation
- Pad Mount Installation
- Introduction
- Required Tools
- Installation Location
- Preparing the Transformer Pad
- Preparing for Installation
- Performing the Installation
- Extend Pad Mounting Bracket
- Attach Pad Mounting Bracket to Lifting Nut
- Attach Conduit Housing to Pad Mounting Bracket
- Insert Conduit Thread into Conduit Housing
- Attach ECN to Pad Mounting Bracket
- Secure ECN to Pad Mounting Bracket
- Connect the ECN to Power and the Network
- Close and Lock the Conduit Housing
- Complete the Installation
- Verifying Successful Installation
- Field Replacement for an ECN 7000 Series Device
- ECN 7000 Series Specifications
- Safety and High-Voltage Warnings
- ESD and Battery Warnings
20 Pad Mount Installation
Figure 10. Secure the ECN to the Pad Mounting Bracket
Connect the ECN to Power and the Network
You make the connections to power and to the communications network at the
bottom of the ECN, which is inside the Conduit Housing.
Figure 11 on page 21
shows the bottom of the ECN, before installation.
You can connect the ECN to either low voltage or medium voltage.
The exact configuration of the ECN bottom panel depends on the options that you
have installed in the ECN, but at a minimum, the bottom panel has a connection
for power and for at least one communications network. In the figure, the bottom
left connection is for power.