User's Manual

Federal Communication Commission Interference Statement
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20 centimeters between the radiator
and your body.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or
transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may
cause undesired operation.
FCC Caution: To assure continued compliance, any changes or
modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this
equipment.
(Example - use only shielded interface cables when connecting
to computer or peripheral devices).
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the
following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
Bluetooth
Specifications
A- LINK:pairing (turn on/off the bluetooth module power)
B- :play / stop
C- LANG.: language selection
Instruction:
A.Press “LINK” button for 4 seconds, enter to pairing setting.
B. the red/blue light flash, automatically searching device pairing in 10 mins.
Pairing matched blue light is keeping flash. No pairing match the light will shut off
after 10 mins automatically.
C.Press “LANG” button 2 seconds for setting up language, introduction Language in order of
English / Chinese / Spanish / French / German. For setting the demand language,
press “LANG” button again when the language is playing.
**Suggestion: When language is set, please turn off the power for memory system to set
completely.
LINK
LANG
MIN MAX
Frequency range:2402~2480 (ISM BANDS)
MODULATION METHOD:GFSK,π/4-DQPSK, 8-DPSK
Transmission power:Typical 2.66dBm, Peak value:3.16dBm
Sensitivity: -89.5dBm (GFSK, 0.1% BER, 1Mbps)
RF input impedance: 50 ohm
Baseband crystal OSC: 26MHz