User's Manual

64 | P a g e www.eccel.co.uk
6. Compliance
A. This module has been tested in accordance with FCC rule part 15.225 and ISED RSS-210 using the
integrated coil antenna permanently fixed within the product.
B. The host product manufacturer is responsible for compliance to any other FCC rules or ISED standards
that apply to the host not covered by the modular transmitter certification. E.g. The final host
product should be fully tested to the requirements of 47 CFR 15B / ICES-003 where applicable,
including AC powerline conducted emissions test with the RFID reader module(s) in operation in the
host product if that host product connects to the AC powerline.
C. The Host device must be affixed with a permanent label that is clearly visible and states the
following: “Contains FCC ID: 2ALHY-000537”. Contains IC: 22592-000537”. Please see FCC KDB
784748 D01 Labelling Part 15 &18 Guidelines v08 section 8 and RSP-100 Issue 11 section 3.2 for
further details on labelling requirements.
D. RF exposure evaluation and exemption has been demonstrated and calculated within the filing for a
worst case distance of 5mm, and considers the use of 4 modules simultaneously.
L'évaluation et l'exemption de l'exposition RF ont été démontrées et calculées dans le dossier pour
une distance de 5 mm dans le pire des cas, et prennent en compte l'utilisation de 4 modules
simultanément.
E. Changes or modifications not expressly approved by Eccel Technology Ltd could void the user's
authority to operate the equipment.
Les changements ou modifications non expressément approuvés par Eccel Technology Ltd pourraient
annuler le droit de l'utilisateur à faire fonctionner l'équipement.
F. This device complies with Part 15 of the FCC Rules and Industry Canada licence exempt RSS
standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.