Users Manual

2. Press the MEAT button until the LCD displays PROG (program). Press the ▲or ▼ buttons to raise or lower the set
temperature. Press and hold the buttons to rapidly increase or decrease the temperature values.
3. Once the current temperature reaches the target temperature for Probe 1 or Probe 2, Probe3, Probe4, the receiver
will sound an alarm.
4. Press any button to stop the alarm.
12. Set and Monitor BBQ Temperature
You can use the 4 probes to measure and monitor the ambient temperature inside your smoker, barbecue or oven.
Remember to clip the selected probe(s) to the rack of the barbecue or smoker.
1. Press the MEAT button until the LCD displays BBQ.
2. Press the TASTE/HI/LO button to switch to the LO temperature setting.
3. Press the TASTE/HI/LO button to switch to the HI temperature setting. Press the ▲or ▼ buttons to set your
desired HI BBQ temperature. Press and hold the ▲ or ▼ buttons to rapidly scroll through digits. The HI BBQ
temperature range is 140 °F - 572 °F（recommended temperature range）and the default setting is 250 °F.
4. Press the ▲or ▼ buttons to set your desired LO BBQ temperature. Press and hold the ▲or ▼ buttons to rapidly
scroll through digits. The LO BBQ temperature range is 32 °F - 554°F（recommended temperature range）and the
default setting is 225 °F.
5. Press the S./S./ /CLEAR button to turn on/off the alarm.
Note: The HI BBQ will not allow you to set the temperature below the LO BBQ temperature.
Note: The LO BBQ temperature alarm will not be activated until the actual BBQ temperature goes above the set LO
temperature.
13. Set a Timer
Count Down Timer
1. Press and hold the PROBE/TIMER button for 3 seconds to switch to TIMER mode. If done correctly, the timer will
display 00:00 and a small timer icon will be shown in the upper part of the display.
2. Press the TASTE/HI/LO button to select between an Hour/Minute timer and a Minute/Second timer.
3. Press the ▲or ▼ buttons to adjust the initial timer setting. Press and hold the ▲ or ▼ buttons to rapidly adjust
timer setting. Press the S./S./ /CLEAR button to confirm this setting.
Note: the maximum countdown timer setting is 99 hours and 59 minutes
4. After you complete setting the timer, press the S./S./ /CLEAR button to start the timer. If done correctly,
TIMER ▼ will be blinking, indicating the countdown timer is running.
5. To pause the countdown timer, press the S./S./ /CLEAR button. TIMER ▼ will become solid. If you wish to
clear the timer, press and hold the S./S./ /CLEAR button. If you wish to continue the timer, simply press the
S./S./ /CLEAR button.
6. Once the countdown timer reaches 00:00, an alarm will sound for one minute. Press any button to stop the alarm.
Note: When the timer counts down below 1:00 hour, the display will automatically adjust to which indicates 59
minutes 59 seconds. The seconds will then begin to count down.
Count Up Timer
1. Press and hold the PROBE/TIMER button to switch to the TIMER mode. If done correctly, the timer will display
00:00 and a small timer icon will be shown in the upper part of the display.
2. Press the S./S./ /CLEAR button to start count up. The TIMER ▲ will blink indicating the count up timer is
running. The maximum count uptime that can be reached is 99 hours and 59 minutes.