User`s manual

EC-520 User’s Manual
- 4 -
2.3.1 Connecting the Cash drawer Cable
Make sure the printer is turned off. Plug the interface cable into the cash drawer connector of
the printer and the other end connector to cash drawer.
Must use the cash drawer following the requirement noted by Table A-1 (Part 5.2) ，or the printer
damage caused by this reason is out of maintenance service by our corporation.
2.3.2 Connecting the Parallel Interface Cable
1. Make sure that the host computer and the printer are both turned off, connect the parallel
interface cable to the connector of the printer, and tighten the screws as shown in Figure 2-3.
2. Connect the other end of the cable to the host computer’s parallel connector, and tighten the
two screws on both sides.
3. This printer’s parallel interface can be connected to network printing server.
2.3.3 Connecting the USB Interface Cable
1. Plug the A side of USB interface (square type) into the printer’s USB interface connector.
2. Plug the B side of USB interface (flat type) into the computer’s USB interface connector.
Fi
g
ure 2-3 Connectin
g
the parallel interface cable
Figure 2-2 Connecting the cash drawer cable
Cash drawer connector
Cash drawer cable
Wire clip
Parallel interface
Parallel interface cable