User`s manual

EC-520 User’s Manual
- 15 -
Chapter 4 Loading Paper
The printer can use the paper with the width 76mm or 57.5mm, and it is easy to load paper. How to
load paper will be introduced in this chapter.
1. Press the open button to open the roll paper cover. If you want to use 57.5mm paper roll to print,
you must install the 57.5mm roll paper guide and 57.5mm partition board, and set the paper
parameter (as shown in Part 5.2).
2. Take the paper roll into the paper filler (Note the direction the paper pulled out of the roll, as shown
below).
3. Turn on the printer, then hold both edges of the paper and insert it straight into the paper insert slot
until the paper is fed automatically.
Note: Paper head must be even, or the paper cannot be fed. If this phenomenon happens, you
must pull out paper head and cut evenly the paper head, and load paper once again.
4. Close the roll paper cover and press FEED key to set the beginning print position.
Note: The loading paper procedure of EC-520C (with auto-cutter) is the same with that of
EC-520 (without auto-cutter)
Roll Paper Cover