User`s manual

EC-520 User’s Manual
- 10 -
3.2 Printer Default Setting
3.3 Explanation for Printer setting Items
1. Through the inside setting of the printer (EC-520, with Parallel Interface or USB Interface), you
can set the following items: black mark setting、print direction , paper width.
① Black mark setting
Black mark setting can be selected by “Black mark invalid “ or “Black mark valid “. You can
select the function by the paper type ( with or without black mark ). “Black mark valid “is
selected in the factory default setting.
 Print Direction setting
Bidirectional printing and Unidirectional printing;
Bidirectional printing is the factory default setting.
 Paper width setting
76mm and 57.5mm
2. Through the inside setting of the printer (EC-520, with Serial Interface), you can set the
following items: Interface type、Baud rate、Parity selection mode、Data length、Stop bit、Control
mode、Black mark setting、Print direction、paper width.
① Interface Type
RS-232 interface
② Baud Rate
9600bps, 19200bps;
”9600bps” is the factory default setting.
③ Parity Check Mode
“No check mode”, “Even check mode “and “Odd check mode”;
EC-520 9Pins Mini Printer V2.00
Have no Cut 200903110KY76F
Black Mark setting： Valid
Print Direction： BI-DIR
Paper Width： 76mm
Figure 3-2 EC-520/C Default Setting ( Parallel and USB Interface )
EC-520 9Pins Mini Printer V2.00
Have no Cut 200903110KY76F
Interface： RS-232
Baud Rate： 9600
Parity check： No
Data length： 8 bits
Stop bit： 1bit
Control mode： DTR/DSR
Black Mark setting： Valid
Print Direction： BI-DIR
Paper Width： 76mm
EC-520C 9Pins Mini Printer V2.00
Have Cut 200903110KY76F
Black Mark setting： Valid
Print Direction： BI-DIR
Paper Width： 76mm
Figure 3-3 EC-520/C Default Setting ( Serial Interface )
EC-520C 9Pins Mini Printer V2.00
Have Cut 200903110KY76F
Interface： RS-232
Baud Rate： 9600
Parity check： No
Data bit length： 8 bits
Stop bit： 1bit
Control mode： DTR/DSR
Black Mark setting： Valid
Print Direction： BI-DIR
Paper Width： 76mm