User Manual
Table Of Contents
Chengdu Ebyte Electronic Technology Co,;Ltd E32-868T30S user manual
Copyright ©2012–2020,Chengdu Ebyte Electronic Technology Co.,Ltd.
16
and longer transmitting time
The air data rate must keep the same
for both communication parties.
0
1
0
2.4k (default)
0
1
1
4.8k
1
0
0
9.6k
1
0
1
19.2k
1
1
0
19.2k (same to 101)
1
1
1
19.2k (same to 101)
General Specifications
Except for E32 (400T20S)
4
CHA
N
7
6
5
reserved
Write 0
Communication channel
00H-1FH, correspond to
862~893MHz
4 ~0, channel (862MHz+CHAN * 1MHz), default 06H
(868MHz)
5
OPTI
ON
7
Fixed transmission enabling bit(similar to
MODBUS)
In fixed transmission mode, the first
three bytes of each user's data frame
can be used as high/low address and
channel. The module changes its
address and channel when transmit.
And it will revert to original setting
after complete the process.
0
Transparent transmission mode
1
Fixed transmission mode
6
IO drive mode (default 1)
This bit is used to the module
internal pull-up resistor. It also
increases the level’s adaptability in
case of open drain. But in some
cases, it may need external pull-up
resistor.
1
TXD and AUX push-pull outputs, RXD pull-up
inputs
0
TXD、AUX open-collector outputs, RXD
open-collector inputs
5
4
3
wireless wake-up time
The transmit & receive module
work in mode 0, whose delay time is
invalid & can be arbitrary value.
The transmitter works in mode 1
can transmit the preamble code of
the corresponding time continuously.
When the receiver works in mode 2,
the time means the monitor interval
time (wireless wake-up). Only the
data from transmitter that works in
mode 1 can be received.
0
0
0
250ms (default)
0
0
1
500ms
0
1
0
750ms
0
1
1
1000ms
1
0
0
1250ms
1
0
1
1500ms
1
1
0
1750ms
1
1
1
2000ms
2
FEC switch
After turn off FEC, the actual data
transmission rate increases while
anti-interference ability decreases.
Also the transmission distance is
relatively short.
Both communication parties must
keep on the same pages about
turn-on or turn-off FEC.
0
Turn off FEC
1
Turn on FEC (default)