Tus neeg siv phau ntawv
Table Of Contents
- Disclaimer
- 1 Product overview
- 2 Specification and parameters
- 3 Size and pins definition
- 4 Recommended circuit diagram
- 5 Hardware design
- 6 E108-Product test
- 7 Command format
- 7.1 GKC interface data format
- 7.2 GKC command
- 7.2. Response message
- 7.2.2 System reboot
- 7.2.3 Erase auxiliary information
- 7.2.4 Low power mode
- 7.2.5 Message interval configuration
- 7.2.6 Periodic low power mode
- 7.2.7 Set star search mode
- 7.2.8 Save star search mode
- 7.2.9 Serial port parameter setting
- 7.2.10 Set NMEA output
- 7.2.11 GPD document delete
- 7.2.12 Set NMEA serial port parameter
- 7.2.13 PPS configuration
- 7.2.14 Query message interval
- 7.2.15 Return message interval
- 7.2.16 Set NMEA output frequency
- 7.2.17 Query NMEA output frequency
- 7.2.18 Return the NMEA output frequency
- 7.2.19 Set reference coordinates
- 7.2.20 Query Reference Coordinate System
- 7.2.21 Return Reference Coordinate System
- 7.2.22 Query RTC time
- 7.2.23 Return RTC time
- 7.2.24 Set the speed threshold
- 7.2.25 Set HDOP Threshold
- 7.2.26 Get HDOP Threshold
- 7.2.27 Version number query
- 7.2.28 Return the current version number
- 7.2.29 Set location and time information
- 7.2.30 Set positioning mode
- 7.2.31 Query ID information
- 7.2.32 Return ID information
- 7.3 Support NMEA0183 protocol
- 8 GDP User Guidance
- 9 FAQ
- 10 Welding instruction
- 11 E108 Series
- 12 Packing for batch order
- Revision history
- About us
Chengdu Ebyte Electronic Technology Co.,Ltd. E108-GN User Manual
Copyright ©2012–2021
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
2
13
3.3 E108-GN02D pins definition
No.
Name
Direction
Function
1
CE
Power enable
terminal
Power enable terminal, can be pulled low to enter low power mode
(default is high)
2
1PPS
1PPS output
1PPS output, the user can set the frequency, duration, etc. through
commands
3
GND
Module power ground wire
4
TXD
output
UART output (2.8V level)
5
RXD
enter
UART input (2.8V level)
6
VCC
Module power supply (3~5.5V)
(The module startup voltage needs to provide a stable voltage of 4.2V. If
the startup voltage is lower than this value, it may cause no printout of
the serial port. After startup, it can be reduced to normal 3.3V voltage
operation.)