Cut Sheet

Eliminate ﬂaring for fast leak free connections

EBRILSMART MAKES INSTALLATION “SMART”

EBRILSMART technical characteristics

DWorking temperature: -45°C to 150°C

DMaximum operating pressure: 45 bar

DSuitable for all refrigerants HCFC, HFC, HC

DTriple metallic seal

DCompatible with traditional 45° ﬂare ﬁttings

DIt is not required the use of a torque wrench

for the installation

DTo be used exclusively on R220 annealed copper tubes

and OH111 aluminium tubes

EBRILSMART certiﬁcation

DTested according to the requirements in Standard UL 109

DConformity with European Directives (PED, RoHS and REACH

DSuperior performance than the traditional 45° ﬂare ﬁttings

Leakage test EN 1779.B6

Test which calculates the annual loss

of refrigerant, the recommended

threshold is 1 g/year; it was

measured a loss of < 50 mg/year

Burst test EN 378-2

Test in which is evaluated the

pressure resistance of the ﬁttings,

ﬁttings were tested and

remained intact at a maximum

pressure of 200 bar

LABORATORY TESTS

Instructions to perform a proper installation of EBRILSMART

Tutorial on

Insert the tube, previously cut and deburred,

into the nut and the insert the sleeve. Bevel

of sleeve toward nut. Lubricate the inner

surface of the nut.

PAGE 1
Eliminate ﬂaring for fast leak free connections EBRILSMART MAKES INSTALLATION “SMART” EBRILSMART technical characteristics EBRILSMART certiﬁcation DWorking temperature: -45°C to 150°C DTested according to the requirements in Standard UL 109 DMaximum operating pressure: 45 bar DConformity with European Directives (PED, RoHS and REACH DSuitable for all refrigerants HCFC, HFC, HC DSuperior performance than the traditional 45° ﬂare ﬁttings DTriple metallic seal DCompatible with traditional 45° ﬂare ﬁtt
PAGE 2
Apply pressure to hold tube against male ﬂare body while hand tightening. Mark pipe-nut location then follow wrench tightening directions. If necessary maintain pressure on tube until nut tightening prevents tube drift. Mark the starting point and make a complete turn and a half with the aid of a common wrench. In the event that the nut needs to be unscrewed for inspection the following installation requires that half a turn is made via a common wrench (after manual screwing is done).