User guide

13-3-2014 13 ebode TAKE6 IR/RF
• Set the remote back to factory default.
How to set the TAKE 6 Remote back to factory default
• Press and hold S (8) until the LED indicator (2) lights
steadily. Release S.
• Press and hold S (8) until the LED indicator (2) lights
steadily. Release S.
• Press and release the 0 key (14) once.
• Press and release the S key (8).
• The LED (2) turns off after few seconds.
6. Tips & Tricks about learning IR codes to a remote
When learning IR codes always test the IR codes directly
during the learning process.
In this way you do not need to learn all the codes over
and over again.
Please try the following steps when the learned IR code
fail to work.
1. Make sure the original remote you are learning the
code from has a fresh set of batteries. (preferably
Duracell or Energizers)
2. Increase/decrease the distance between the two
remotes when learning. (original and URC)
Try for example to double the distance, up to 4 feet is
possible.
3. For ‘normal’ short burst codes, try to ‘tap’ the button
instead of press and holding it.
4. For ‘Continuous’ codes, try the ‘flicker’ technique –
rapidly tap the button while learning. (approximately
7x per second or faster.)
5. Try the ‘Swoop’ method, Start form 2’ away and then
‘swoop’ the remote towards the learning remote.
6. Try the ‘Flasher’ method. Hold an opaque object in
front of the remote and remove it then quickly
replace it.
7. Try learning the codes to another learning remote
first, and then from that remote to the required one.