User guide

16-8-2010 7 033000=15090C

4. Setup

4.1 Using the Wizard

a) After you insert the batteries you can select your preferred language and then the Setup

Wizard screen [1] appears. Press any key at this screen to continue with the wizard. You can

exit at any time by pressing the HOME key (located just below the screen).

[1] [2] [3]

b) Pressing OK at screen [2] takes you to the next screen [3]. Pressing the Left navigation key

on the remote at screen [3] takes you to screen [4] that has 10 yellow arrows. Normally the

Left navigation key will get you back to the previous screen but this screen is an exception to

the rule to help you learn how the remote functions. Pressing the Back key again at screen 4

will take you back.

c) Try pressing the Back key a few times to go back through the Wizard and then follow the

instructions on the screens again to familiarize yourself with how to step through the screens

and go back.

You can go back and forth through the Wizard but once you’ve set up your devices and quit

to save the settings, you won’t see the Wizard again unless you do a Master Reset.

Pressing any of the 10 Side Keys (K1 thru K10) at screen

[4] takes you to the screen where you set up your first

device (TV).

See the Setting Up Your Devices section below.

NOTE: To do a Master Reset: Press the HOME key, select

Setup, select Advanced,

select Clear Settings, then select Master Clear.

This will erase everything you have set up in the remote.

4.2 Setting up your devices

For a known brand

After you have been through the Wizard for the first time, screen [1] shown to the right

appears. This is the start of the Wizard to set up your devices (TV being the first one).

Please note that the device you are setting up will need to be switched on prior to

programming the universal remote.

If you know your brand of TV, select ‘Yes’, this results in a faster search for your TV’s code.

K10

[4]