User manual

March 2013 IPV68
69
You can enter http://www.dyndns.com and register an account.
Pop-up the prompt” Fail to connect to the device…”?
This prompt only appears in the case of using multiple cameras.
When you set multiple cameras, and the device status light changes to yellow please make sure the
cameras are connected to power and working correctly.
5.2 Default Parameters
Default network Parameters
IP address: dynamic
Subnet mask: dynamic
Gateway: dynamic
DHCP: Disabled
DDNS: factory DDNS and third party DDNS
Username and password
Default administrator username: admin
Default administrator password: None, i.e., no password, please leave blank
6.0 Specifications
Model
IP Vision 38 (IPV38) / IP Vision 38 WideEye (IPV38WE)
Image Sensor
Sensor
1/4” Color CMOS Sensor
Resolution
640 x 480 Pixels (300k Pixels)
IR Lens
IPV38 – f: 6.0mm, F 2.0 IPV38WE – f: 3.6mm, F 2.0
Viewing Angle
IPV38 – 60 Degree IPV38WE – 90 Degree
Minimum Illumination
0.5Lux @ F2.0
Video / Image Setting
Video Compression
MJPEG
Video Frame Rate
15fps(VGA), 30fps(QVGA)
Resolution
640 x 480(VGA), 320 x 240(QVGA)
Flip Mirror Images
Vertical / Horizontal
Light Frequency
50Hz, 60Hz or Outdoor
Video Parameters
Brightness, Contrast
Audio talk-back
Built-in Mic
Communication
System Interface
10Base-T/100Base-TX Ethernet Port
Supported Protocols
TCP/IP，DHCP，SMTP，HTTP，DDNS，UPNP，PPPoE, FTP, DNS, UDP, GPRS
Wireless LAN
Supports wireless networks (Wi-Fi/802.11/b/g)
WEP Encryption
Disable / 64 bit / 128 bit
WPA/WPA2 Encryption
TKIP / AES
Physical / Environment