Operation Manual

31-7-2014 77 ebode IPV38P2P
8.1.9 UPnP always failed
UPnP only contains port forwarding in our recent software. Sometimes, it may be failed
to do port forwarding automatically because of firewall or anti-virus software. It also has
much relation with router’s security settings. So we recommend you do port forwarding
manually. You can view your camera in internet successfully after you do port forwarding
manually in your router.
8.1.10 Camera cannot connect wireless
If your camera could not connect wireless after you set wireless settings and plug out the
cable. Please check whether your settings are correct or not. Normally, camera can’t
connect wireless mainly because of wrong settings. Make sure broadcast your SSID; use
the same encryption for router and camera.
8.1.11 Can’t see other cameras listed
Can’t see other cameras listed in multi-device when using remote access. If you want to
view all cameras via the WAN, verify that each camera added in the multi-device settings
can be accessed by using the DDNS name and port number. Use the DDNS domain name
not the camera’s LAN IP. (For more details see: How to add cameras in WAN).
8.2 Default Parameters
Default network Parameters
IP address: obtain dynamically
Subnet mask: obtain dynamically
Gateway: obtain dynamically
DDNS: Embedded domain name
Username and password
Default username is admin with a blank password.
8.3 Specifications
Item
Image
Sensor
Sensor
High Definition Color CMOS Sensor
Display Resolution
1280 x 720 (1Megapixels)
Min. Illumination
0 Lux (With IR Illuminator)
Lens
Lens Type
Glass Lens
focal length
f:2.8mm
Aperture
F2.4
Angle of View
70°
Video
Image Compression
H.264
Image Frame Rate
30fps maximum, downward adjustable
Resolution
720P (1280 x 720), VGA (640 x 480), VGA (640 x
360), QVGA (320 x 240), QVGA (320 x 180)
Stream
dual stream
Image adjustment
The hue, brightness, contrast, saturation,
sharpness are adjustable
Flip image
flip and mirror