Operation Manual

31-7-2014 55 ebode IPV38P2P
6.4.4 Snapshot Settings
On this page you can set the snapshot pictures’ image quality and the storage path.
Figure 6.51
Manual snap Quality: Low, middle and high. The higher the quality, the picture will be
clearer.
Alarm Pictures Save To: FTP or SD Card. If you have done FTP and Alarm settings, when
alarming, the camera will snap pictures to the FTP automatically. If select SD Card as the
save path, make sure the camera has inserted in the SD card.
Enable timing to capture
To enable capture interval, follow the steps below:
1 Select Enable timing to capture
2 Capture interval: The interval time between two captures.
3 Select the capture time
 Capture anytime, click the black button up the MON, you will see all time range turn
red. When something moving in the detection area at any time the camera will capture.
 Specify an capture schedule, Click the week day words, the corresponding column will
be selected. For example, click TUE, the all column of TUE turns to red, that means
during Tuesday whole day, the camera will capture.
 Press the left mouse and drag it on the time boxes, you can select the serial area,
4 Click Save button to take effect.
6.4.5 IR LED Schedule
On this page you can set the schedule time for switching IR LED lights. When parameter
Mode is set to the Schedule on the Live Video window, at these schedule time, the IR
LED lights will be turned off.