Operation Manual

31-7-2014 44 ebode IPV38P2P
③ Use domain name to access the camera via internet
After the port forwarding is finished, you can use the domain name+ http no. to access
the camera via internet. Take hostname ycxgwp.no-ip.info and http no 2000 for example,
the accessing link of the camera via internet would be http:// ycxgwp.no-ip.info:2000
6.3.5 UPnP
Figure 6.31
The default UPnP status is closed. You can enable UPnP, then the camera’s software will
be configured for port forwarding. Back to the “Device Status” panel, you can see the
UPnP status:
Figure 6.32
The camera’s software will be configured for port forwarding. There may be issues with
your routers security settings, and sometimes may error. We recommend you configure
port forwarding manually on your router (Figure 6.30).
6.3.6 Port
This camera supports HTTP Port / HTTPS Port/ ONVIF Port. HTTP Port is used to access
the camera remotely. If you want to access the camera and view the video.
HTTP port : By default, the HTTP and Media port is set to 88. Also, they can be assigned
with another port number between 1 and 65535. But make sure they cannot be conflict
with other existing ports like 25, 21.
Figure 6.33