Installation & Assembly

Step 4
Stand the Table right way up. Place the Table on a LEVEL SURFACE to check for
wobbles.
If it wobbles, lift the table some 20cm to 30cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the table freely and vertically with all four legs, hitting the ground, at the same time.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolts fully and then towards the next one.
This could cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute the same drop test.
If the Table is not stable, it could lead to damage to the product.
Your End Table is ready for use.
This Table can only be used on a flat, level surface.
4 OF 4