Caution : You must read this before you proceed End Table Label Picture Description QTY A Table Top 1 B Left Leg Frame 1 C Right Leg Frame 1 1 OF 4
Label Picture Description QTY ① Bolt (M8*20mm) 7 ② Allen key 1 Before Beginning Assembly: Overview Table Top (A) Left Leg Frame (B) Right Leg Frame (C) FRONT FACING This End Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all parts on a clean, non-marring surface. Step 2 Place the Table Top(A) face down on the clean and soft surface. 2.1) Insert Left Leg Frame(B) into Table Top(A) as shown above. 2.2) Attach Left Leg Frame(B) to Table Top(A) using Bolts(①) with Allen key(②) as shown above. Do not fully tighten the Bolts. Step 3 Repeat Step 2, to attach Right Leg Frame(C) to Table Top(A). Do not fully tighten the Bolts.
Step 4 Stand the Table right way up. Place the Table on a LEVEL SURFACE to check for wobbles. If it wobbles, lift the table some 20cm to 30cm high from the ground. Keep your feet and toes well away from the drop zone. Drop the table freely and vertically with all four legs, hitting the ground, at the same time. When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolts fully and then towards the next one. This could cause the frame to warp.
