Owner Manual

Gas Set-Up for Natural Gas

1. With burner in place in our fire pit table or

other installation location and proper sized orifice inserted in burner neck

(see chart on p.4 for natural gas orifice sizing),

adjust air shutter to a

closed position (as shown at right, no light visible through the shutter) by

loosening the small screw on the air shutter and rotating it to a closed

position and re-tightening screw.

2. Locate the included metal flex-line hose and thread one end onto orifice

and tighten securely with two wrenches.

3. At this point you have two options for plumbing natural gas. If using a

valve assembly such as the fire table key valve kit, proceed to step 3a.

a. Attach the free end of flex hose to the top (outgoing) flare fitting of

control valve and tighten fully with two wrenches. Plumb incoming

natural gas to the incoming side of the valve using a 3/8” flare nut.

It is strongly recommended that a manual shutoff valve is placed in

the natural gas line before it reaches the fire pit’s control valve.

CHECK ENTIRE SYSTEM FOR LEAKS BEFORE OPERATING

Flare Nut

Orifice

Venturi/Air shutter

-OR-

Outdoor GreatRoom Co. Control panel kit

Incoming gas

Out to burner

Fire Table Key Valve

OrceFlare Nut

Out to Burner

Incoming Gas

Venturi/Air Shutter

4 GAS HOOK-UP AND INFORMATION (CONTINUED)