Manualshelf

Assembly & Operating Instructions

ManualsBrandsEbern Designs ManualsLightingBernardyn LED 8-Light Outdoor Armed Sconce with Motion Sensor
12345678910
3
CHOOSING A LOCATION FOR YOUR DUAL HEAD LED SECURITY SPOTLIGHT:
This Dual Head LED Security Spotlight provides safety and security around your home. It is ideal for lighting
up
areas
where
electricity
is
not
available
such
as
porches,
driveways,
carports
outside,
garages
and
entrance areas.
of 130º at a distance of up to 26 feet when the surrounding temperature is 75°F. The outside temperature
will impact the detection distance. As temperatures get colder the motion sensor will become more sensitive
and the range of the motion sensor will increase.
HOW TO INSTALL YOUR DUAL HEAD LED SECURITY SPOTLIGHT:
TOOLS REQUIRED FOR INSTALL:
If mounting to wood or a softer surface, you only need a Phillips-head screwdriver If mounting to concrete,
brick, or a harder surface, a drill should be used to create mounting holes first.
Use the included mounting bracket and (2) screws with rubber washers to mount the Dual Head LED
Security Spotlight securely to a wall.
TO INSTALL THE MOUNTING BRACKET:
1.
Remove the mounting bracket from the back of the light by unscrewing the (one)
thumb screw and pushing the button at the top of the base of the back of the light.
2.
Hold the mounting bracket up to the wall where you want to mount it.
3.
If you need to drill, use the holes in the mounting bracket to identify where to drill on the
mounting surface. Once identified, remove mounting bracket and drill holes in the mounting
surface.
4.
Once you have drilled the holes or if no drilling is needed, hold the mounting bracket back up
to the mounting surface. Drive the screws completely in, securing the mounting bracket to
the mounting surface.
Make sure the rubber washers are under the heads of the screws.
5.
Tighten both screws and slide the light over the mounting bracket until the button on
top clicks into place. Then replace the thumb screw in the bottom of the light and
mounting bracket.
Put one gasket in and one
screw through this hole.
Put other gasket in
and one screw
through this hole.
Rubber
gasket (x2)