Assembly & Operating Instructions

INCLUDED PARTS:

Carefully remove and identify all the parts from their protective packaging and lay them out in front of you.

Adjustment dials are located on the backside of the motion sensor as shown in the pictures below. Grab

the black plastic area of the motion sensor and rotate it until you see the adjustment dials. The dials are

located on the black plastic part of the motion sensor on the side opposite of the front, denoted by an

arrow and the word FRONT on the motion sensor.

INSTALLING/REPLACING THE BATTERIES:

When the batteries run out of power, you can replace the batteries with 3 new C-Cell batteries. Follow the

steps below when replacing the battery.

1. Switch the Dual Head LED Security Spotlight to OFF.

2. Remove the Dual Head LED Security Spotlight from its mounted back.

Remove the thumbscrew from the bottom of the back of the Dual Head LED Security Spotlight.

Gently press on the button on the top of the back of the Dual Head LED Security Spotlight and

pull the light away from the mounting bracket.

If replacing old batteries, carefully remove the old batteries from the battery tray and

three (3) new C-Cell batteries into the battery tray. Ensure that the new batteries are inserted in

the correct +/- polarity orientation as indicated in the battery compartment.

WARNING: BATTERIES

INSTALLED INCORRECTLY COULD POTENTIALLY DAMAGE THE UNIT.

4. Press the Dual Head LED Security Spotlight back into the mounted back until the top button clicks

5. Replace the thumb screw in the bottom of the back of the Dual Head LED Security Spotlight.

6. Switch the Dual Head LED Security Spotlight back to AUTO

NOTE: DO NOT DISPOSE OF BATTERIES IN GENERAL HOUSEHOLD TRASH OR INTO A

FIRE SINCE THE BATTERIES MAY EXPLODE. CONSULT YOUR LOCAL REGULATIONS FOR

CORRECT DISPOSAL OF BATTERIES. DO NOT TAKE APART THE BATTERIES SINCE THEY

CONTAIN CORROSIVE CHEMICALS.

Rotate this section