Installation Instruction

2
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (C1) and the gasket (E1) from the mounting back plate.
4. Remove the screw (D1) from the top cover.
5. Drill holes in the wall aligned with the key holes located in the mounting plate, insert the plastic anchor (F1).
6. Secure the mounting back plate to the junction box using junction box screws (B1), fasten it to the wall using wood screw (G1), the side of
the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
7. Connect the xture’s wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
8. Insert the glass to the xture; secure it
with top cover using screw (D1).
9. Secure the xture to the mounting back
plate using the mounting screw (C1) and
the gasket (E1).
10. To prevent moisture from entering the
outlet box and causing a short, use clear
caulking (i.e. indoor/outdoor silicone
sealant) to outline the outside of xture
back plate where it meets the wall. Leave
a space at the bottom to allow moisture
to escape Fig. 3.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Junction Box
Caulking
Fig. 3 Sealing
FIG.1
Wood Screw
Gasket
Mounting Screw
Plastic Anchor
Junction Box Screw
Wire Connector
Ground Wire
Screw
Mounting Backplate
Junction Box
Fixture
Glass
Top Cover
G1
E1
C1
F1
B1
A1
D1
Back Plate Dimensions
23 5/8”
8 1/2”
Ø7 1/8”
Ø5 1/2”
INSTALLATION INSTRUCTION
LED Outdoor