Installation Instruction

2
FIG.1
Mounting Screw
Junction Box Screw
Wire Connector
Mounting Plate
Gasket
C1
B1
A1
D1
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screw (C1) and silicon gasket (D1) from the xture.
4. Secure the mounting back plate to the junction box using junction box screws (B1). The side of the mounting back plate marked
“GND” must face out.
5. Connect the xture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture;s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junctino box.
MOUNTING THE FIXTURE (Fig. 1)
6. Secure the xture to the mounting back plate using the mounting screw (C1) and silicon gasket (D1).
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig. 3.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House W
ires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Junction Box
Caulking
Fig.3 Sealing
Back Plate Dimensions
1 1/2"
1 3/4"
INSTALLATION INSTRUCTION
LED Outdoor
5"
6"
7 3/4"
11 3/4"