Assembly Instructions ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and & being difficult, Formosa Philips Screwdriver Nol laud) products, two persons are recommended.
90-DAY LIMITED REPLACEMENT PARTS WARRANTY This tern comes with a 0-day limited replacement parts warranty to the original purchaser of new products against defects in materials and workmanship for a period of ninety (90) days from the date of receipt. This warranty is not transferable.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST, CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES Hyde highly recommended halt assembly Should BE Dane nerd the arts of fs intended location, Make Sif yeu Have Sad Ugh Space To move around during the assembly ALLAYS have 81 sas in people te Bast with trans porting snd fricasseeing {hie protract ta avid any potential infancy landlord damage.
PER-ASSEMBLY INTRODUCTION Unless your are particularly adept at assembling flat-antiknock-down furniture ‘we understand building ready-to-assemble failure bean frustrating experience for some. To help avoid confusion and to make the assembly process quicker and smoother we have provided some helpful tips. Before you begin the assembly.
CAM LOCK FASTENER ASSEMBLY INSTRUCTIONS Note: Every cam lock bolt must have a cam Jock connector in order to fasten the parts together, {fH Align the cam connector with its Secure the threaded i side opening (or arrow) end of the cam bolt pointing to the small by using a drilled hole. screwdriver. i < Turn right (clockwise) to tighten, Two parts should fit snugly (3) against each other. Insert the cam lock bolt into the per-drilled hole above the cam connector.
ASSEMBLY INSTRUCTIONS STEP: 3 Hardware (2) x PCS Hardware (8) x PCS Hardware (7) x PCS STEP : 4 Hardware (3) x PCS Hardware (5) x PCS Hardware (8) x PCS be tightened until alf bales (#3) are connected fo bolts ond (45). If connector (#8) tills and docs not align 0 the holes, then loosen all belies (#3) from halt ends (5) hal way allow you ta realign connectors (4 all holes. Nee all bolts ¢¢3) and Holt ends (43) ure connected, then full tighten bolts (#3) onto boll ends (75).
ASSEMBLY INSTRUCTIONS Make sure the unit is rested on a flat surface and does not feel loose or wobbly. If it does, double check all bolts/screws are secured and properly tightened.
