User manual

Application and function
The compact TS+ Thermal Actuator covers a wide
range of control and regulating applications in
heating, cooling and air circulation. Applications
include:
• Individual room controls for underoor heating
systems and radiators
• Zone controls
• Multi-circuit regulators for one and two pipe
systems
Features
• 230 V and 24 V variants
• Normally closed
• Manual position (to open valve by hand)
• can be mounted in any direction
(even upsidedown)
• Silent operation
• Stroke position is visible under the cover
• Compact and stylish construction
Dimensional drawing
Technical Data
For 230 V version TS+ 5.11
Supply voltage 230 V AC 50 Hz
Inrush current <1A
Opening time 3 - 4 Min.
Power Consumption 2.5 W
For 24 V version TS+ 6.11
Supply voltage 24 V AC
Inrush current <0.5A
Opening time 5 Min.
Power Consumption 2.5 W
For both versions:
Actuator type Normally closed
Ingress Protection IP 54
Isolation Class II
Stroke length 4.5 mm
Closing force 90 N or 120 N
Closing time 2-3 mins
Valve connection M 30/M 28x1.5 mm
Weight ~120 g
Operating temperature 0 … 50 °C
Storage temperature –25 … 70 °C
Shock load voltage 2.5 KV
Temperature for
Ball Pressure Test
100 °C
Voltage and Current for
EMC Test
230 V, 0,1 A
Installation and
commissioning instructions
Thermal Actuator
TS+
Mounting and Installation
1. The TS+ should be mounted in the
manually-open position (as supplied)
– see Picture 3
2. Screw the TS+ onto the valve. Hand tighten
only
3. Press and turn the cover clockwise until the
click position. The markings on the TS+ should
line up (see Picture 4)
NOTE: the TS+ will only work properly in the clo-
sed position (see Picture 4)
Electrical Connection
WARNING: Disconnect from mains
before installing
Connections according to wiring diagram:
WARNING:
The TS+ should only be installed by a
suitably-qualied person.
All valid health and safety regulations must
also be complied with.
The Thermal Actuator TS+ is suitable for the
opening and closing of valves in dry and en-
closed rooms in normal ambient conditions.
The product conforms to EN 60730.
Function
The Actuator opens the valve when electrically
activated. This call for heat normally comes from
a control device (thermostat). Without power the
TS+ closes automatically
The current position of the valve can be seen
using the position indicator:
Valve Valve
Open Closed
Picture 1 Picture 2
Manual position
Using the manual function the valve can be
opened by hand.
To open the valve:
Press the cover and turn anticlockwise. The cover
and bezel markings are then out of alignment
(see Picture 3). The valve is now open
To close the valve:
Press and turn the cover clockwise until it clicks.
The cover and bezel markings are now in align-
ment (see Picture 4)
Valve Valve
Open Closed
Picture 3 Picture 4
NOTE: the TS+ will only work properly in the
closed position (see Picture 4)
468 931 003 497-6
red
position
indicator
t
This product should not be disposed of with
household waste. Please recycle the products
where facilities for electronic waste exist. Check
with your local authorities for recycling advice.