Specifications

TM 9-2330-384-14&P

5-3. BRAKE SHOE REPAIR (Con't).

c. INSTALLATION OF BRAKE SHOE LININGS

NOTE

• Keep hands clean when handling brake linings.

DO NOT confuse brake lining cam (2) with brake lining anchor (1). Brake

lining anchor has smaller cross-section and is tapered.

(1)

Clamp brake lining anchor (1) and brake lining cam (2) to brake shoe table (4) with rivet holes

alined. Locate C-clamps as close as possible to rivet holes.

(2)

Starting at center and working toward ends, drive new rivets (3) squarely into holes.

(3)

Use a feeler gage to check brake lining cam (2) and brake lining anchor (1) to brake shoe

table (4) clearance. No more than a 0.006 in. (0.15 mm) feeler gage can fit between lining

and brake shoe table (4) along edges.

FOLLOW-ON TASKS:

Install brake shoes (see paragraph 4-35).

5-9