Specifications

TM 9-2330-384-14&P
4-80. PIPINGASSEMBLY,FRONTPORT,ANDREARINLETMAINTENANCE(Con't).
d. INSTALLATIONOFREARINLETCOMPONENTS
(1)
Install preformed packing (22) and poppet assembly (21) on piping assembly (6) flange.
(2) Loosely install new gasket (19) and fitting (20) on piping assembly (6) flange with six screws (16),
12 washers (17), and six new locknuts (18).
(3) Install brake interlockangle bracket (14), as marked, on rearof piping assembly (6) flange with two
remaining screws (16), four washers (17), and two new locknuts (18). Tighten all eight locknuts in
a crisscross pattern.
18
14
17
COD
17
16
6
21
2
19
20
e. REMOVAL OF PIPING ASSEMBLY
23
2
(1) Disconnect precheck tubing from
precheck fittings at piping assembly.
6
1\
Remove fittings from piping assembly
(see paragraph 4-72).
(2) Disconnect control cable and tubing
at emergency valve (24) (see
24
paragraph 4-76).
22
25
4-262
Change1