Specifications

TM 9-2330-384-14&P
4-61. PIPING ASSEMBLY SUPPORT BRACKET REPLACEMENT.
a. Removal b. Installation
Equipment Conditions:
Ref Conditions
--
Piping assembly supported with jack-
stand.
Materials/Parts:
Four locknuts
Four lockwashers
Tools:
Tool kit, general mechanic’s
a. REMOVAL
CAUTION
Use caution when removing air lines (10) from clips. Clips should be
lifted gently and only enough to release air lines. Improper handling of
clips will cause them to break.
Use caution not to damage air lines (10).
(1) Remove brake interlock air lines (10) from clips at support bracket (4).
(2) Remove four nuts (8), lockwashers (7), washers (9), and two U-bolts (6) securing piping
assembly to support bracket (4). Discard lockwashers.
(3) Remove four locknuts (3) eight washers (2), and four screws (1). Remove support bracket
(4) from frame (5). Discard locknuts.
b. INSTALLATION
CAUTION
Use caution not to damage air lines (10).
(1) Install support bracket (4) to frame (5) with four screws (1), eight washers (2), and four new
locknuts (3). Tighten locknuts securely.
(2) Install piping assembly to support bracket (4) with two U-bolts (6), four washers (9), new
lockwashers (7), and nuts (8).
4-186