Specifications

TM 9-2330-384-14&P
4-52. LANDING GEAR REPLACEMENT.
THIS TASK COVERS
a. Removal
c.
Installation
b.
Cleaning
INITIAL SETUP
Equipment Conditions:
Ref Condition
2-11 Wheels chocked.
2-12 Semitrailer parked on level ground
and coupled to tractor.
--
Landing gear raised.
Tools:
Tool kit, general mechanic’s
Torque multiplier
Torque wrench
Personnel Required: Two
Materials/Parts:
Two retaining rings
Nine locknuts
Dry cleaning solvent (Item 10,
Appendix E)
Mylar tape
(Item 24, Appendix E)
General Safety Instructions:
Landing gear is heavy and awkward to han-
dle. Use caution, provide adequate sup-
port, and use assistance during removal
and installation.
Dry cleaning solvent is flammable and must
not be used near open flame. Use only in a
well-ventilated area.
a.
REMOVAL
NOTE
Removal of curbside landing gear leg (11) is described. Roadside land-
ing gear leg is removed the same, except that it has no handcrank (9).
If removing sand shoe, perform step 7.
(1) Unstow handcrank (9) from clip
(10) on landing gear leg (11). Re-
move locknut (5), two washers
(6), and screw (7). Remove hand-
crank. Discard locknut.
4-161