Specifications

TM 9-2330-384-14&P
4-36. CAMSHAFT REPLACEMENT.
THIS TASK COVERS
a.
b.
Removal
C.
Installation
Cleaning and Inspection
Equipment Conditions:
Ref
Conditions
4-35 Brake shoes removed.
4-37 Slack adjuster removed,
Tools:
l Tool kit, general mechanic’s
l Retaining ring pliers
l Torque wrench
Materials/Parts:
l One bushing
l One retaining ring
l Two bearings
l Four locknuts
l Six preformed packings
l Dry cleaning solvent
(Item 10, Appen-
dix E)
l Grease
(Item 12, Appendix E)
References:
l TM 43-0139
General Safety Instructions:
l Dry cleaning solvent is flammable and must
not be used near open flame. Use only in a
well-ventilated area.
NOTE
l For ease of removal, it may be necessary to remove carc paint from
camshaft (16) (see TM 43-0139).
l If removing both camshafts (16) from same axle, tag camshafts. Left-
hand and right-hand camshafts are not the same.
a. REMOVAL
(1)
(2)
Remove washer (7) from splined end of camshaft (16).
Remove retaining ring (11) from groove of camshaft (16) on inboard side of spider (1) and
discard,
(3)
Drive camshaft (16) from camshaft bracket (8). Remove washer (12) from inboard side of
spider (1).
(4)
(5)
Drive camshaft (16) from spider (1).
Remove one bearing (14) with preformed packings (13 and 15) from spider (1) and discard.
Remove other bearing (14) with preformed packings (13 and 15) from camshaft (16) and
discard.
(6)
Remove washer (18) from camshaft (16).
(7)
Remove four locknuts (3), washers (4), and bolts (6), and separate camshaft bracket (8)
halves. Remove bushing (10). Discard locknuts and bushing.
4-104