Specifications

TM9-2330-384-14&P
4-23. CONVOYWARNINGLIGHTASSEMBLYMAINTENANCE(Con't).
(2)
Place a bead of silicone compound around
cable (9) at base of convoy warning light (13).
(3)
Position convoy warning light (13) over base
plate (12). Secure convoy warning light (13) to 1
base plate (12) with three bolts (15), washers
(14), new lockwashers (11), and nuts (10).
Torque nuts 10-20 lb.-in. (1-2 N-m).
NOTE
If repairing/replacing wire, crimp
2
two new terminals onto ends of
3
bared wires prior to performing
step 4.
4 5
(4)
Plug two terminals (4) onto convoy warning
-'0111
4
light (13). Connect black cable wire (6) to
positive connection, and connect white cable
'0@
6
wire (5) to negative connection.
CAUTION
Before installing dome (1), ensure
that white and black cable wires
7
(5 and 6) are under rotating
14,
mechanism (8) ofconvoy warning
.4
light (13). Failure to follow this
caution may result in damage to
13
8
lightor cable wires.
NOTE
Ensure that gasket (7) of convoy
12
warning light (13) is in position
before installing dome (1). 11
(5)
Install new gasket (7) and dome (1) over
convoy warning light (13). Install clamping
ring (2) and screw (3), and tighten screw.
FOLLOW ON TASKS:
• Install convoy warning light to mounting bracket
(see paragraph 2-23).
• Check operation of light (see TM 9-2320-273-10
or TM 9-2320-283-10).
Change1
4-61