Specifications

TM 9-2330-384-14&P
4-23. CONVOYWARNINGLIGHTASSEMBLYMAINTENANCE.
THISTASKCOVERS
a. Disassembly
b. Assembly
INITIALSETUP
Equipment Conditions: Materials/Parts:
Ref Conditions - Two terminals
2-23 Convoy warning light removed from
- Three lockwashers
mounting bracket. - Silicone Compound (item 18.1,
Appendix E)
Tools:
• Tool kit, general mechanic's
• Torque wrench
• Wire terminal kit
a. DISASSEMBLY
(1)
Loosen screw (3) from clamping ring (2). Remove clamping ring (2), dome (1), and gasket (7) from
convoy warning light (13). Discard gasket.
(2) Unplug two terminals (4) of white and black cable wires (5 and 6) from convoy warning light (13).
Tag and mark wires.
NOTE
Perform step 3 only if repairing wire.
(3)
Cut terminals (4) from white and black cable wires (5 and 6) and discard.
(4)
Remove three nuts (10), lockwashers (11), bolts (15), and washers (14). Separate convoy warning
light (13) from base plate (12). Discard lockwashers.
(5)
Pull away cable (9) from base of convoy warning light (13).
b. ASSEMBLY
CAUTION
Ensure that only component parts of the convoy warning light assembly, as
listed in Appendix D, are used. The M1062 convoy warning light draws a
maximum of 5 amperes. Use of another convoy warning light, which draws
more than 5 amperes, may result in damage to electrical system.
(1)
Thread cable (9) through hole in base of convoy warning light (13) so that encased portion of cable
extends at least 3 in. (7.6 cm) from base. White and black cable wires (5 and 6) should be bared
for 3 in. (7.6 cm) from encased portion of wire.
4-60 Change1