Specifications

TM 9-2330-384-14&P
4-22. CONVOY WARNING LIGHT WIRING MAINTENANCE.
a.
Removal of Toggle Switch
C. Removal of Condulet and Receptacle
b.
Installation of Toggle Switch d.
Installation of Condulet and Receptacle
Equipment Conditions:
Materials/Parts:
Ref Conditions
2-14 Intervehicular electrical cable discon-
nected from semitrailer.
Tools:
Tool kit, general mechanic’s
Hand drill
Rivet gun
Wire terminal kit
One gasket
Two connectors
Two locknuts
Corrosion preventive compound (Item 7,
Appendix E)
Tag marker (Item 21, Appendix E)
General Safety Instructions:
l When performing electrical maintenance,
ALWAYS disconnect intervehicular electri-
cal cable from semitrailer.
a. REMOVAL OF TOGGLE SWITCH
WARNING
When performing electrical maintenance, ALWAYS disconnect inter-
vehicular electrical cable from semitrailer. Failure to follow this warning
may create a spark and explosion, resulting in serious injury or death to
personnel.
NOTE
Tag wires for installation if lights are being removed from light box (1).
(1) Remove four screws and pull stop/taillight (4) away from light box (1) enough to gain access
to wiring inside (see paragraph 4-20).
NOTE
Toggle switch (3) terminals should be marked to ensure proper installation
of terminals (2).
(2) On outside of light box (1), remove rubber boot from toggle switch (3).
(3) Remove nut and toggle switch (3).
(4) Remove two screws and disconnect two terminals (2) from toggle switch (3) inside light box
(1).
4-56