Specifications

TM 9-2330-384-14&P
4-20. STOP/TAILLIGHT MAINTENANCE.
Button Contact Repair C.
Installation
Removal
Equipment Conditions: Materials/Parts:
Ref
Conditions Two button contacts
2-14 Intervehicular electrical cable discon-
Two connectors
nected from semitrailer.
Corrosion preventive compound (Item 7,
Appendix E)
Tools:
Tag marker
(Item 21, Appendix E)
Tool kit, general mechanic’s
Wire terminal kit
General Safety Instructions:
When performing electrical maintenance,
ALWAYS disconnect intervehicular electri-
cal cable from semitrailer.
a. BUTTON CONTACT REPAIR
WARNING
When performing electrical maintenance, ALWAYS disconnect lnter-
vehicular electrical cable from semitrailer. Failure to follow this warning
may create a spark and explosion, resulting in serious injury or death to
personnel.
CAUTION
(1)
(2)
(3)
(4)
(5)
(6)
(7)
4-48
Use caution not to damage lens (8).
Use a screwdriver to carefully lift up on lens (8) and remove. Remove lamp (7).
Remove four screws (5) and pull stop/taillight (4) away from light box (1) enough to gain
access to wiring inside light box.
Loosen two grommets (9) and pull brown wire (2) and red wire (10) through stop/taillight (4).
Cut brown wire (2) and red wire (10) from two button contacts (6).
Install two new button contacts (6) to ends of brown wire (2) and red wire (10). Crimp button
contacts.
To ensure proper operation of stop/taillight (4), hold stop/taillight so that deeper slot of
socket is to the top. Thread brown wire (2) and red wire (10) through two grommets (9). Seat
grommets in stop/taillight with red wire to the right.
Install lamp (7).