Specifications
TM 9-2330-384-14&P
Section II. SERVICEUPONRECEIPT
Paragraph
Page
Number
Title
Number
4-4
General
.................................................................................................................
4-2
4-5
Inspection Instructions ..........................................................................................
4-2
4-6
Servicing Instructions ............................................................................................
4-3
4-4.
GENERAL.
When an M1062 7500 Gallon Fuel Tank Semitrailer is first received by the using unit, determine
whether it has been properly prepared for service and is in condition to perform its mission. Follow the
inspection instructions found in paragraph 4-5 and the servicing instructions found in paragraph 4-6.
4-5. INSPECTION INSTRUCTIONS.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective
goggles, face shield, and gloves, and use only in a well-ventilated area. Avoid
contact with skin, eyes, and clothes and DO NOT breathe vapors. DO NOT use
near open flame or excessive heat. The solvent's flash point is 100*F-138*F
(38*C-59*C). If you become dizzy while using cleaning solvent, immediately
getfreshairand medical help. If solvent contacts eyes, immediately wash your
eyes with water and get medical aid.
a. Use dry cleaning solvent (item 10, Appendix E) to clean all exterior surfaces coated with rust
preventive compounds.
b. Remove any protective materials used on semitrailer during shipment. Unpack and properly stow
all Basic Issue Items (BII).
c. Perform Semiannual (S) preventive maintenance checks and services found in Table 4-1.
Correct any deficiency, if authorized by the Maintenance Allocation Chart (MAC) in Appendix B. If not
authorized, notify direct support maintenance.
WARNING
Grablhandles on top of semitrailer are dismountable. Be sure that they are
securely fastened before using them. Failure to follow this warning may result
in serious injury to personnel.
d. If semitrailer was shipped without grabhandles, unstow and install (see paragraph 2-22).
e. Make a complete visual inspection of the semitrailer to ensure that all accessories and required
publications are present.
4-2
Change1