User Manual

10 11
Place the bedside controller on a hard, flat surface at the height
of your pillow and near a wall outlet. Always place the bedside
controller on a hard, flat surface in a well-ventilated area. Keep
the vents clear of obstructions.
!
WARNING:
• Ebb should not be used close to or stacked with other electrical equipment.
• Do not block the inlet or outlet areas of the enclosure and keep at least one foot of clearance around all side of the bedside controller to prevent overheating.
• Do not place Ebb bedside controller on the floor where it can be bumped
• Not for use in an oxygen-rich or flammable anesthetic environment or where someone is likely to trip over the power cord.
• Route the electrical cord to prevent a tripping hazard or being entangled with furniture.
• Do not position Ebb so it is difficult to unplug the power cord from the electrical outlet.
• Do not use extension cords.
• Use only a power supply provided by Ebb Therapeutics. Use of any other power supply may result in increased emissions or decreased protection of Ebb device
which could impact the performance of the unit. Keep the power supply away from hot surfaces.
• Ebb is isolated from the mains by means of the supplied medical grade power supply. Do not use a power supply other than the one supplied with the system.
Set Up
1
Connect Headband
2
CAUTION:
Before each use, make sure the headband tubing is properly connected to the back of the bedside controller.
Insert headband to back of
bedside controller until you
feel it click.
Tug firmly on the headband
tubing to make sure it is
inserted correctly.