User Manual

28 29
Electromagnetic Compatibility
Ebb complies with all applicable electromagnetic compatibility requirements (EMC) IEC 60601-1-2 4th edition and meets the Class B Group 1
emissions requirements in CISPR 11. Ebb has met the Home Healthcare Immunity requirement levels.
EMC in the Home:
WARNING:
Portable radio frequency communications equipment (including items such as antenna cables and external antennas) should be used
no closer than 12 inches to any part of Ebb, including cables specified by the manufacturer. Otherwise, loss of the performance of this
equipment could result.
• Ebb must be installed and put into service according to the Electromagnetic Capabilities (EMC) information provided in this manual.
• Mobile radio-frequency communications equipment can affect the device.
• Ebb may shut down or display an error code if the device experiences a radio-frequency interference caused by another electronic device.
Under these conditions, the user should move mobile devices that may cause radio waves that effect the normal operations of Ebb and then
continue use.
!
EMC Accompanying Document
Ebb requires special precautions regarding EMC and needs to be installed and put into service according to the EMC information provided in
these accompanying documents.
WARNING:
A risk of increased emissions or decreased immunity may result if any additional cables are attached.
Use of this equipment adjacent to or stacked with other equipment should be avoided because it could result in improper operation. If such
use is necessary, this equipment and the other equipment should be observed to verify that they are operating normally.
Use of accessories, transducers and cables other than those specified or provided by the manufacturer of this equipment
could result in increased electromagnetic emissions or decreased electromagnetic immunity of this equipment and result in
improper operation.
!
!
!
Guidance and manufacturer’s declaration – electromagnetic emissions
Ebb is intended for use in the electromagnetic environment specified below. The customer or the user of Ebb should assure that it is used
in such an environment.
Emissions test Compliance Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1 Ebb uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in
nearby electronic equipment.
RF emissions
CISPR 11
Class B Ebb is suitable for use in all establishments, including domestic
establishments and those directly connected to the public
low-voltage power supply network that supplies buildings used for
domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Complies