Installation Guide

Page 11 of 13
Drawing : - TPC 400
Issue : -1
Date : -21/02/13
ROUTINE MAINTENANCE & REPAIR
To ensure continued full efficiency of the dehumidifier, maintenance
procedures should be performed as follows:
• We recommend that the filters are checked at least once a month.
Intervals for cleaning or replacement of filters will depend on the
installation
• Never operate the dehumidifier without the filters, as the rotor can be
damaged by dust.
To carryout the following, it is necessary to remove the side panels.
This machine should be serviced by qualified Ebac Industrial Products Ltd
personnel or other persons having technical competence in servicing
electrical equipment following the instructions in this Service Manual.
• The rotor is maintenance free. However, should it be necessary to
clean the rotor, compressed air should be used to carefully blow dirt
from the rotor.
• The heaters are maintenance free. However should it be necessary to
clean the heaters, compressed air should be used to carefully blow dirt
from the heaters.
• Check that the fans are firmly secured and that the fan rotates freely.
• Check all wiring connections.
• Check the belt tensioning at regular intervals.
• The overheat protector is located inside the unit, below the desiccant
wheel. To reset this device press the red button.
• Should an electrical component fail, consult the Factory Service Center
to obtain the proper replacement part.
WARNING:
ENSURE THAT THE POWER CORD TO THE MACHINE HAS
BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE
MAINTENACE.
SWITCH OFF THE DEHUMIDIFIER APPROXIMATELY 15
MINUTES PRIOR TO REMOVING ANY PANELS, ALLOWING
THE HEATER TO COOL DOWN