Owner`s manual

Page 10

5. If an Output Channel has already been configured you will be asked to reassign the

selected Output to the selected leg.

6. Set the Amp Gain and Amp Volts RMS for the associated leg.

7. Repeat steps 4 through 6 for each additional Greybox leg.

8. Set the Listener Distance for the Greybox.

9. Set Delay applied to all legs of a Greybox.

10. Set Gain applied to all legs of a Greybox.

5.6.2 XOVER SETUP

Use the Xover Setup submenu to select High and Low Pass Filters applied to Output

Channels. Setting Pass Filters on an Output Channel tied to a Greybox leg will adjust the

appropriate filters for all Output Channels tied to the Greybox.

5.6.3 COMP/LIM SETUP

Press OK to select parameter for the Comp/Lim submenu. To advance vertically through the

submenu press and hold the left or right arrow key for at least 2 seconds.

Lim: Sets the Comp/Lim to In (active) or Out (inactive)

Atk: Scroll through and select the limiter threshold from 20 dBu to -10 dBu in 0.1 dB steps.

Thrsh: Scroll through and select the limiter threshold from 20 dBu to -10 dBu in 0.1 dB steps.

Rel: Scroll through and select the limiter release from 10 ms to 2 Sec in 10 ms steps.

Ratio: Scroll through and select the compression ratio in integer increments: 1:1 to 20:1, or Inf:1

Knee: Select the aggressiveness of the onset of limiting between a hard or soft knee.

5.6.4 PROGRAM

The UX3600 has memory spaces for 50 user-savable and loadable programs. You can Save

a program, Load a program, or Delete a program from this submenu.

Save Press Ok to select Save from the Program submenu.

Use the up and down arrow to scroll through the 50 program slots in the memory.

Press Ok to select a memory slot.

Using the up and down arrow keys to select a character and the left and right

arrow keys to step between characters give your program a name.

Press enter to save when finished

Load: Press OK to select Load from the Program submenu.

Use the up and down arrow buttons to select a previously stored setting if any

settings have been stored.

Press OK to select program. When prompted “Modifies current settings.

Proceed?”, use the up or down arrows to select Yes or No.

Press the OK button to enter.

Delete: Press OK to select Delete from the Program submenu.

Use the up and down arrow buttons to select a previously stored setting if any

settings have been stored.

Press OK to delete program. When prompted “Modifies current settings.

Proceed?”, use the up or down arrows to select Yes or No.

Press the OK button to enter.

5.6.5 UTILITIES

Use the utilities submenu to view or change the following information about the processors

operations:

Device Name: You can change the name that appears on the LCD of your UX or in