Owner`s manual

5.2.6 MUTE BUTTONS
Input Mutes: Mutes the output signal of the corresponding Input Channel.
Output Mutes: Mutes the signal to the output XLR.
When a channel is muted the top two segments of the corresponding meter will be illuminated.
Mute settings are not saved with and therefore not recalled from Program files saved in the processor’s
memories. However, the behavior of the mutes may be changed when a program is recalled according
to the Program Load setting made in the UTIL menus.
In contrast, mute settings are saved as part of EAWPilot files (*.ept files) and are uploaded to the
processor as part of the settings stored in those files.
5 . 3 L e v e l
Use the LEVEL function to set Input Channel or Output Channel gain and Polarity by selecting
the A to C or 1 to 6 buttons.
GAIN: To change the gain parameter use the OK button to select and use the up or
down arrow button to scroll by 0.1dB steps +/- 15dB. Press OK when
finished to enter selected gain.
POLARITY: To change the POLARITY parameter use the OK button to select and use the
up or down arrow buttons to switch between Normal and Inverted polarity.
Press OK when finished to enter selected polarity.
When a Greybox has been loaded changes made to one Greybox output leg will be applied to
all output legs associated with the same Greybox.
5 . 4 E Q
Use the EQ function to set the Input Channel EQ and Output channel EQ (EQ is disabled for
outputs tied to a Greybox) by selecting the A to C or 1 to 6 buttons. Each channel’s EQ section
has 10 filters. Each EQ section has the following variable parameters. The available
parameters depend on the selected type.
Parametric
EQ: Sets the entire EQ section to In (active) or Out (inactive).
Type: Scroll through and select the type for each filter: Bell, 6 dB LoShelf,
12 dB LoShelf, 6 dB HiShelf, 12 dB HiShelf, 6 dB HPF, 12 dB HPF, 6 dB LPF,
or 12 dB LPF.
BW: Scroll through and select the bandwidth for each filter:0.02 to 10 octaves.
Freq: Scroll through and select the frequency for each filter : 20Hz to 20k, 1/24th
octave steps.
Gain: Scroll through and select the gain for each filter: +/- 15dB in 0.1dB steps
Filt: Sets the filter (1 to 10) to In (active) or Out (inactive)
5.4.1 TURNING ALL PARAMETRIC EQ ON OR OFF FOR A SELECTED CHANNEL
From the EQ menu use the right arrow key to select the In/Out parameter. Use the up or down
arrow key to select In or Out. To set parameters for an individual filter press the right arrow
button. To set parametric EQ In or Out without moving into individual filters press the OK
button.
5.4.2 SETTING FILTER PARAMETERS FOR AN INDIVIDUAL FILTER (1 THROUGH 10)
Page 8
OUTPUTS
C
lip
Lim
-
12
Sig
M
UTE
1
C
lip
Lim
-12
Sig
MUTE
2
Clip
L
im
-
12
S
ig
M
UTE
3
Clip
Lim
-12
S
ig
MUTE
4
Clip
Lim
-12
S
ig
MU
5