Owner`s manual
5 OPERATION - I N I T I A L S E T U P
WARNING: A digital processor provides a wide range of signal processing parameters. The
results of using incorrect or improper parameters with a loudspeaker can range from poor
sound quality to damage to the loudspeaker. Be sure any settings you make do not cause the
capabilities of the drivers in the loudspeaker system to be exceeded.
5 . 1 Po w e r O n / O f f
CAUTION: Before powering on the processor, make all connections to the processor and
ensure there is no audio signal present at the processor’s inputs.
Use the UX3600’s rear panel power switch to turn the AC Mains supply to the processor on and off.
Always follow prudent audio system practices and procedures for powering on equipment by powering
up all equipment in the direction of the signal flow order, meaning from the input to the output of the
audio system. Power down the equipment in the reverse of this orde
r.
5 . 2 F r o n t P a n e l C o n t r o l s
5.2.1 DISPLAY
The LCD (liquid crystal display) screen, along with the function buttons and arrow keys provides the
user interface for operating the processor from the front panel.
5.2.2 FUNCTION BUTTONS
Use the function buttons to display and edit the operating parameters.
LEVEL Gain and polarity
EQ Channel EQ
DELAY Channel signal delay
MENU Channel setup and Global settings
NOTE: Some function buttons will have no corresponding screen depending on the mode of
operation and the channel selected. This will be indicated in the display.
5.2.3 ARROW BUTTONS & OK
This is the primary control for operating the UX3600 from the front panel. Arrow buttons are used
to navigate and change parameter values. The OK button is used to select or set parameters.
5.2.4 INPUT CHANNELS: BUTTONS A TO C
Pressing an INPUT channel button will display the selected function’s parameters for this input.
5.2.5 OUTPUT CHANNELS: BUTTONS 1 TO 6
Pressing an OUTPUT button will display the selected function’s
parameters for this output.
Clip
-6
-12
Sig
MUTE
A
Clip
-6
-12
Sig
B
Clip
-6
-12
Sig
C
MUTE MUTE
INPUTS
L
G
L
OUTPUTS
Clip
Lim
-12
Sig
MUTE
1
Clip
Lim
-12
Sig
MUTE
2
Clip
Lim
-12
Sig
MUTE
3
Clip
Lim
-12
Sig
MUTE
4
Clip
Lim
-12
Sig
MUTE
5
Clip
Lim
-12
Sig
MUTE
6
Page 7
UX 3600
Speaker / System Processor
OK
LEVEL
E
Q
DELAY
MENU
Channel Setup
Xover Setup
System Menu
MENU